Parkside Performance PDSSAP 20-Li D3 Bedienungsanleitung Und Originalbetriebsanleitung Seite 41

3. Select the speed level (see "Selecting
the speed level .
4. Press and hold the on/o switch
S i i
1. Release the on/o switch
2. Wait until the product has stopped
before placing it down.
3. When taking a break: Push the
rotational direction switch
middle position. This prevents the
product from being switched on
accidentally.
4. Remove the battery pack
product if you are leaving the product
unattended or if you have nished
working.
˜ Speed control
Progressively controlling the speed:
o
Apply gentle or stronger pressure on
the on/o switch
Pressure
Gentle
Strong
˜ LED work light
NOTE
Improve visibility in poorly lit areas:
u
This product is equipped with a
LED work light
immediate working area.
As soon as the product is switched
o
on The LED work light
immediately.
40 GB/IE
[
.
[ ]
to the
[ 3 ]
from the
7 ] [
.
[ ]
Speed
Low
High
to illuminate the
[ ]
switches on
[ ]
˜ Belt clip
.
CAUTION! Risk of injury!
]
m
Before hanging the product on a
u
belt: Push the rotational direction
switch
[ 3 ]
This prevents the product from being
switched on accidentally.
Hanging the product on a belt: Use the
o
belt clip
8 ] [
You can use the belt clip
o
opener for bottles with crown caps.
˜ Working instructions
NOTICE!
m
Always follow the manufacturer's
u
instructions for tightening screws
or nuts. Follow the manufacturer's
guidelines for the inspection of
screws or nuts in accordance with
time or performance.
After changing a vehicle s wheel s
u
Inspect the wheel bolts or nuts as
requested in the manufacturer's
instructions or guidelines. Tighten
the wheel bolts or nuts with a torque
wrench after approx. 50 to 100 km.
The tightening torque depends on the
o
impact duration.
In order to achieve optimum impact
o
force, do not exert any pressure
against the screw/nut.
Only use the product to tighten screws
o
and nuts for pre-assembly work. It
is not the product that achieves the
desired target torque of the screw or
nut, but a torque wrench that is set to
the target torque.
Check the tightening torque actually
o
achieved with a torque wrench.
to the middle position.
.
as a bottle
8 ] [