Battery Charging - Mpm Mod-70 Bedienungsanleitung

EN
ASSEMBLY (DISASSEMBLY) OF THE VACUUM CLEANER
CAUTION! Do not operate the vacuum cleaner
when it is not assembled!
CAUTION! Make sure that you do not damage
the delicate connectors powering the electric
brush while assembling the pipe and accessories.
1. Assemble the electric brush (4) to the aluminium
pipe (3). Then assemble the aluminium pipe (3)
with the motor module (2). Finally, assemble the
ba琀琀ery (1) with the motor module (2) (昀椀g. 1).
2. In order to disassemble the vacuum cleaner act
similarly to the 昀椀rst point.
PARKING THE VACUUM CLEANER
SWITCH ON THE HANDLE
The MOD-70 vacuum cleaner is provided
with a handle that allows the vacuum cleaner
to be 昀椀xed to the wall. In order to use the
handle, 昀椀x it to the wall.
1. Choose a suitable
place at the right
height to
modate the vacuum
cleaner together
with the pipe (3) and
the electric brush (4)
Makes sure that no
electrical cables have
been laid in the wall
at the chosen loca-
琀椀on.
2. Place the bracket (5) on the wall and mark the
hole posi琀椀ons on the wall with a pencil (昀椀g.2)
3. Drill holes at the marked loca琀椀ons, insert the
wall plugs, apply the handle and screw in the
screws. Park the vacuum cleaner and accessories on the screwed handle (5).

BATTERY CHARGING

CAUTION! Charge the ba琀琀ery before using the vacuum cleaner for the 昀椀rst 琀椀me. The 琀椀me re-
quired to charge the ba琀琀ery is approximately 4.5 – 5.5 hours.
CAUTION! Only charge the ba琀琀ery with the supplied charger. While the ba琀琀ery is charging, the
vacuum cleaner cannot be started.
There are two ways in which the vacuum cleaner can be connected to the charger in order
to charge the ba琀琀ery. Charging the ba琀琀ery alone or charging the vacuum cleaner in the
wall-mounted handle:
1. Press the key and slide the ba琀琀ery (1) out of the motor module (2) (昀椀g.3).
32
MOD-70_instrukcja_v02.indd 32 MOD-70_instrukcja_v02.indd 32
昀椀g. 2
accom-
昀椀g. 1
29.11.2023 10:00:49 29.11.2023 10:00:49