Troubleshooting; Environment Concerns; Declaration Of Conformity - Klarstein 10027831 Anschluss- Und Anwendungshinweise

Symtom
No heat, No fan
No heat, No fan
Slow drying
Uneven drying
Overheating or
insuffi cient heat
Noisy fan/motor
According to the European waste regulation 2012/19/EU this symbol on the product
or on its packaging indicates that this product may not be treated as household was-
te. Instead it should be taken to the appropriate collection point for the recycling of
electrical and electronic equipment. By ensuring this product is disposed of correct-
ly, you will help prevent potential negative consequences for the environment and
human health, which could otherwise be caused by inappropriate waste handling of
this product. For more detailed information about recycling of this product, please
contact your local council or your household waste disposal service.
Producer: Chal-Tec GmbH, Wallstraße 16, 10179 Berlin.
This product is conform to the following European Directives:
2014/30/EU (EMC)
2014/35/EU (LVD)
2011/65/EU (RoHS)
13

Troubleshooting

Possible cause
No power
Broken wire in unit
Trays overfi lled
Fan jammed or running
to slowly.
Air leaks due to warped
or improperly stacked
trays
Variation in food thick-
ness and ripeness
Trays not rotated
Too much food in dry-
ing trays
Temperature control
not functioning at pro-
per range
Foreign matter in fan
Motor bearing worn

Environment Concerns

Declaration of Conformity

Possible solution
Be sure the unit is plugged in.
Make sure the power is switched on.
Check the outlet is working.
Not use repairable. Return for service.
Air must fl ow freely around food for proper drying.
Reduce quantity in trays or rearrange food.
Check for foreign objects jamming fan (see-Heat-
ok, no fan above).
Check that the food on trays is not blocking air
fl ow through tray stack. Make sure central chim-
ney of tray is not obstructed.
Check that the food is of similar thickness.
Rotate trays once or twice during dehydrabon pro-
cess.
Check that the food on the trays is not blocking air
fl ow through tray stack make sure central chim-
ney of tray is not obstructed.
Temperature in the lowest tray should be approx.
(60°C) with empty trays in place. If temperature
varies signifi cantly, adjust accordingly higher or
lower or return for service.
Check for foreign objects jamming fan (see-Heat-
okno fan above).
Return for service.