Fasep RASE.3030. VARIANT Betriebsanleitung Seite 145

b. Check that the beads are correctly
inserted in the rim; otherwise, defl ate the
tyre, break the beads as described in the
relevant section, lubricate and turn the tyre
on the rim. Repeat the mounting operation
described previously and check again.
Risk of explosion. During the bead insertion phase, do not exceed the maximum
pressure indicated by the manufacturer on the sidewall of the tyre.
- Once the bead has been inserted, refi t the internal part of the valve and then infl ate
the tyre to the pressure indicated by the vehicle manufacturer.
- If the tyre is over-infl ated, air may be released by pressing the brass manual defl ation
button located below the air pressure gauge (2 - Fig.45)
- Disconnect the infl ation hose from the valve stem.
- Tilt the operating arms into "non-working" position.
User's manual
"HUMP" (H)
"double HUMP" (H2)
WARNING
EN
46
145