Maintenance And Servicing - Vevor Rc-9001 Bedienungsanleitung

4． Continue retrieving cable until you can pull cable by hand. Release foot from
Foot Switch. WARNING! Do not pull cable from drain while cable is still rotating.
The cable can whip around, causing serious injury.
5． Place Rotation Switch in OFF position, dry your hands, unplug machine.
6． Release Tension Knob tension and pull remaining cable from drain by hand
and feed into Drain Cleaner. If needed, change cutting tool and continue
cleaning.

Maintenance and Servicing

Procedures not specifically explained in this manual must be
performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION: Turn the
Rotation Switch of the tool to its "OFF" position and unplug the tool from its
electrical outlet before performing any inspection, maintenance, or cleaning
procedures.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration occurs, have the
problem corrected before further use.
Cleaning Drain Cleaner Cables
1．Thoroughly flush Drain Cleaner cables with clean water after every use. Doing
so will help prevent the build-up of sediment and any drain cleaning chemicals
still in the cable.
2．Once cables have been flushed, carefully tip the Drain Cleaner forward to
empty out any remaining debris.
3．Once the cable is clean and dry, pull the cable from the drum.
4．Lubricate with oily rag as you feed cable back into drum.
WARNING! Do not attempt to remove a rotating cable.
Cleaning/Lubricating Housing
1．Loosen Belt Guard Knob and slide Belt Guard off from top of Drain Cleaner
motor.
2．Use screwdriver to slide belt off back of Drain Cleaner drum.
3．Slide new belt into belt pulley above drum.
4．Slide new belt onto rear of drum until securely in place.
- 21 -