Herunterladen Inhalt Inhalt Diese Seite drucken

VEVOR RC-9001 Bedienungsanleitung Seite 21

Elektrischer rohrreiniger
Vorschau ausblenden Andere Handbücher für RC-9001:
Inhaltsverzeichnis
Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 57
NOTICE
Rotation Switch controls rotation of drum only.
DO NOT USE ROTATION SWITCH REVERSE
POSITION WHILE REMOVING CABLE FROM PIPE.
Use reverse direction only momentarily for relieving pressure or
untangling cable from a blockage.
Warranty void if cable damaged from allowing motor to twist excessively against
blockage, or if drum is run in reverse long enough to unwind cable.
Working Through a Blockage
1. If cutting tool becomes lodged in a blockage and Drain Cleaner is still
operating, cable will start to wind up or twist. If so, release pressure from Foot
Switch and Drain Cleaner motor will stop.
WARNING! Do not let cable build up outside drain.
2. The cable and drum will turn backwards until the tension in the cable is
released.
WARNING! Do not remove gloved hand from cable until all the tension is
released.
3. Put Power Feed Lever in "reverse" position to pull cable back and free
cutting tool from blockage.
4. If motor can't pull cable out, release pressure from Foot Switch and allow
cable to stop spinning. Once cable has stopped spinning, grab cable with both
gloved hands and pull cable free.
5. Once tool is free of blockage and is turning again, slowly feed rotating cutting
tool back into blockage. Do not force tool through blockage. Allow cutting tip to
break up and work through blockage.
CAUTION: While working through the blockage, tool and cable can get
with debris from blockage, preventing further cleaning. The cable and tool will
then need to be retrieved from drain and debris removed.
Retrieving Drain Cleaner Cable
1. Once drain is clear, turn on faucet or use a hose to flush debris out. NOTE: If
water flow slows or stops, resume using the drain cleaner to locate and clear
blockage further down the drain.
2. To retrieve cable, set Power Feed Lever in reverse (up) position but make
sure Rotation Switch is still in Forward position. WARNING! Do not retrieve cable
with Rotation Switch set in Reverse position.
3. Keep one hand on cable. The cable can get caught while being retrieved.
- 20 -
clogged
Inhaltsverzeichnis
loading

Inhaltsverzeichnis