VEVOR RP8628 Bedienungsanleitung Seite 407

Operation
1. Make sure the arrow on the tip handle is pointing in the forward direction
for spraying.
2. Start the sprayer. Refer to the instructions in the sprayer's Manual.
3. Adjust the fluid pressure on the sprayer until the spray is completely
atomized. Always spray at the lowest pressure necessary to get the
desired results. NOTE: The spray tip determines the size of spray pattern
and coverage. When more coverage is needed, use a larger tip instead of
increasing fluid pressure.
4. To clear a clogged tip
A. Rotate the tip 1 80° so that the arrow
on the tip handle is pointing opposite the
spray direction.(7)
B. Trigger the gun once so that the
pressure can blow the clog out. Important:
Never pull the trigger more than once at a
time with the tip in the reverse position.
C. Continue this procedure until the tip is
clear of the clog
Changing a Tip
Tips can be removed and replaced easily without disassembling the gun.
Never attempt to change or clean the tip or tip
guard without first performing the "Pressure
Relief Procedure."
1. Perform the "Pressure Relief Procedure"
described in the sprayer's Manual.
2. Remove the tip from the slot on the tip guard.
3. Insert the new tip into the slot on the tip guard.
The arrow on the tip handle should be pointing in the forward direction.
Removing the Seal and Tip Seal
1. Remove the tip and tip guard from the spray gun.
- 10 -