VEVOR RP8628 Bedienungsanleitung Seite 27

Water-based (Latex) Paint: Flush with warm clean water.
Priming and Startup Steps
1. Separate smaller
Priming Tube from
Suction Tube.
4.Turn Prime/Spray
switch to Prime mode
7.Sprayer will start pumping and water or
flushing solvent well as air bubbles will be
purged from system let fluids discharge
from Priming Tube into waste bucket for 30
to 60 seconds then switch Power to Off
2. Place Priming Tube
in waste bucket
5.Adjust Pressure
Control Knob to
Prime/Clean setting
- 26 -
3. Submerge Suction
Tube in water or
flushing solvent
6. Plug in Sprayer
and turn on power
8. Remove Suction Tube
from water or flushing
solvent and submerge in
paint pail