VEVOR RP8628 Bedienungsanleitung Seite 222

4.Turn Prime/Spray
switch to Prime mode
7.Sprayer will start pumping and water or
flushing solvent well as air bubbles will be
purged from system let fluids discharge
from Priming Tube into waste bucket for 30
to 60 seconds then switch Power to Off
9. Switch Power to On
5.Adjust Pressure
Control Knob to
Prime/Clean setting
10. Paint should work itself from Suction
Tube to Sprayer to Priming Tube until paint
discharges from Return Tube Point gun into
waste bucket and pull trigger
- 29 -
6. Plug in Sprayer
and turn on power
8. Remove Suction Tube
from water or flushing
solvent and submerge in
paint pail