Trumpf TruTool TC 200 Bedienungsanleitung Seite 15

Insert the machine into the tube to be pro-
u
cessed.
Push the machine downward on the
u
guide rods until the machine snaps in at
the lowest position of the guide carriage.
ð Press button 3 when the guide carriage
is on the tube to be processed and the
machine is snapped in at the lowest po-
sition of the guide carriage.
u Release the hand control.
ð The machine continues to run.
ð The machine switches off immediately if
the guide carriage is no longer on the
tube to be processed.
ð The machine switches off immediately if
the machine is no longer snapped in at
the lowest position of the guide car-
riage.
To restart the machine after it has
u
switched off, press the hand control and
turn clockwise up to the stop.
4 Consumables and
accessories
4.1 Tool selection
For notes about the selection of the correct
tool, order specifications for wearing parts
and consumables, and accessories and
spare parts lists, see:
www.trumpf.com
TC 200
(1A5)
4.2 Alternative rechargeable
batteries
This power tool can be used with all 18 V /
5.5 Ah LiHD TRUMPF or CAS rechargeable
battery packs.
Translation of the original operator's manual
5 Troubleshooting
Problem Cause
Tool is Saw chain is
sluggish. dull.
Tool does Rechargeab
not switch le battery is
on. empty or
defective.
6 Repair
Service, changing, and inspection of power
tools must be done properly.
The safety regulations according to DIN
VDE, CEE, AFNOR, and other regulations
valid in individual countries must be adhered
to.
If a connection line must be replaced, have
this repair done by the manufacturer or its
representative to avoid safety hazards.
EN
Remedy
Replace the
u
saw chain.
[} 222]
E
u Check the
charge.
[} 223]
F
Change the
u
rechargeable
battery.
[} 223]
G
15