Stroke Height Gap Wedge Zi-Hs8Pt / Zi-Hs10T / Zi-Hs12T - Zipper ZI-HS8PT Betriebsanleitung

ATTENTION!
Piled wood columns, and wood chips are a source of danger. Always keep the
environment clean, so you can not slip.
 After completion of work, leave the riving knife and arm in the upper position drive (park posi-
tion). Then turn off the engine by pressing the on-off switch to "O" and disconnect the ma-
chine from the mains.
 Let the machine cool down. Thereafter the machine should be cleaned and lubricated if neces-
sary. The splitter may only be vertically stored in a dry and clean place. Make sure that the
cap of the oil tank tightly closed and no oil leakage during storage.

14.2.1 Stroke height gap wedge ZI-HS8PT / ZI-HS10T / ZI-HS12T

For shorter pieces of wood, you can improve performance by shortening the gap diameter re-
trace.
To adjust the riving knife, perform the following steps:
 Raise the trunk on the splitting table and run the riving knife to the desired position. The top
position of the riving knife should then be about 3-5cm above the piece of wood.
 Let go of one control handle, so the splitting blade will stay in that position and turn on the
device.
 Pull out the mains plug.
 Let go of the second control handle.
 Shorten the return on the attached adjusting rod (B), by fixing the locking screw (A) at the
required height.
 Let go of a lever or turn the log splitter from.
 Let go of both lever or turn the engine back on.
 Check the new positions.
Z.I.P.P.E.R Maschinen Austria  www.Zipper-maschinen.at
A: Locking screw
B: Ram travel adjusting rod
HOLZSPALTER / LOG SPLITTER
OPERATING
Seite 34
ZI-HS8PT / ZI-HS10T / ZI-HS12T