Operating; Operating Notes; Operation - Zipper ZI-HS8PT Betriebsanleitung

 Check the motor rotation direction . When you turn on the engine, the riving knife is automati-
cally go to the highest position . If the riving knife should already be in the top position , turn
by moving the two levers down the gap mechanism. Thus, the splitting wedge will move down.
 If there should not move up after turning on the machine, the riving knife , turn the machine
off immediately. Poland it all the engine with a screwdriver in order . If you have this no ade-
quate training, they agree necessarily an electrician .
ATTTENTION!
NEVER START THE ENGINE IN THE WRONG DIRECTION RUN!
THIS INEVITABLY FOR DESTRUCTION OF THE PUMP SYSTEMS AND PURPOSE IS NO
GUARANTEE IS CLAIMED.
14

OPERATING

14.1

operating Notes

ATTENTION!
More columns the wood in the direction of the wood grain. Place the wood never
against a fibration, because that can lead to significant damage to the mechanical and
the hydraulic system.
14.2

Operation

Before you begin working, check the functionality of the log splitter, by performing the following
steps.
 Turn the machine on by pressing the on-off switch from "I".
 Press the two levers down. Thereupon, the riving knife must move down.
 If you release one of the two levers is the riving knife in the instantaneous position.
 When you release both levers, the riving knife automatically moves upwards.
 Keep the log with the two levers, so that a stable state of the wood is guaranteed. Then move
the two levers down to split the wood. If you release one of the two levers, stop the splitting
wedge. When you release both levers, the riving knife automatically moves to the highest posi-
tion.
 Create the split wood parts immediately from the work area and stack them if necessary. This
will reduce accidents at work.
Z.I.P.P.E.R Maschinen Austria  www.Zipper-maschinen.at
HOLZSPALTER / LOG SPLITTER
OPERATING
Seite 33
ZI-HS8PT / ZI-HS10T / ZI-HS12T