Mount Wheels Zi Hs10T / 12T; Hydraulic - Zipper ZI-HS8PT Betriebsanleitung

13.2.3

Mount wheels ZI HS10T / 12T

 Insert the screw M10x20 the screw retain-
ing ring, washer and put the wheel on.
 Then insert is the small and then the large
washer on.
 Let tilt the machine from a second person
easily.
 Insert the pre-assembled wheel on the base
frame and tighten it with a wrench -17 - so
tight that it can still be turned.
13.2.4

Hydraulic

The log splitter is equipped with a hydraulic oil
tank in the base plate and is factory filled with
oil.
CAUTION: When not upright transfer of the log
splitter, oil can escape through the bleed screw.
At low ambient temperatures, the hydraulic oil
assumes a thick consistency.
THEREFORE: Especially at low ambient tem-
peratures, a minimum idle time of 3 minutes
before carefully before EVERY use! Do not
burden at this time the log splitter! Lifting and
lowering you now about 10 to heat the slit as-
sembly times without stress to the hydraulic oil.
Failure to follow this policy may result in dam-
age to the hydraulic system and the warranty is excluded.
Z.I.P.P.E.R Maschinen Austria  www.Zipper-maschinen.at
HOLZSPALTER / LOG SPLITTER
ASSEMBLY
Oil filler cap
Seite 31
ZI-HS8PT / ZI-HS10T / ZI-HS12T