Parkside Performance PPAKS 40-Li A1 Originalbetriebsanleitung Seite 55

Machine part
Chain brake
components
Sprocket (26)
Saw chain (6)
Saw chain (6)
Blade bar (5)
Blade bar (5)
Automatic
oil system
Mounting the saw chain and blade
bar
CAUTION! Cutting injuries! Wear
cut-resistant gloves when working
with the saw chain or with the blade
bar.
Procedure
1. Switch off the tool and remove the
batteries (17) from the tool.
2. Place the device on a level sur-
face.
3. Deactivate the chain brake: Pull
the chain brake lever (4) back to-
wards the front handle (11).
You can only refit the sprocket
cover (9) when the chain brake
band has been released.
4. Turn the wing screw (7) and rotary
wheel for chain tensioner (8) ⭯ to
loosen the chain tension and re-
move the sprocket cover (9).
5. Remove the sprocket cover (9).
6. Push the blade bar (5) towards the
chain sprocket (26).
You can remove the saw chain (6)
and blade bar (5).
Action
Visual inspection,
replace as needed
Visual inspection,
replace as needed
Check saw chain, oil, reg-
rind or replace if necessary
Clean and oil the saw chain
Servicing the
blade bar, p. 56
Turning the blade
bar, p. 57
Check, clean oil pas-
sage if necessary
Before After 10
each use
✓
✓
✓
✓
✓
Changing the saw chain and blade
bar
Prior to changing the saw chain,
the groove of the guide rail must be
cleaned of dirt because dirt depos-
its available can cause the saw chain
to break out of the rail. The deposits
can also absorb the chain oil. So the
consequence would be that the chain
oil would not or only a small part of it
would reach the underside of the rail
and the lubrication would be reduced.
Requirements
• Mounting the saw chain and blade
bar, p. 55
Permitted cutting equipment
• Blade bar
M1431246-1041TL (Trilink)
• Saw chain
CL14346TL (Trilink)
Procedure
1. Replace the blade bar (5)/ the saw
chain (6).
2. Fit the blade bar (5) and saw chain
(6) as described under Installing
the saw chain and blade bar,
p. 56 beschrieben.
GB MT
After
hours each use
of use
✓
✓
✓
55