Inserting And Removing The Battery; Switching On And Off - Parkside Performance Ppaks 40-Li A1 Originalbetriebsanleitung

GB MT
The chainsaw must not touch the
ground!
• Significant trace of oil: The
chainsaw is working properly.
• Slight trace of oil: Check chain
lubrication, adjust oil flow
• No trace of oil: Fill with chain
oil, check chain lubrication,
clean oil passage
Pouring in chain oil
WARNING! Risk of fire! Always
turn off the device and let the engine
cool down before filling with chain oil.
NOTICE! If the chainsaw is used with
too little oil, the cutting performance
and lifespan of the saw chain will de-
crease as the saw chain will become
blunt more quickly. You can recognise
insufficient oil by the smoke develop-
ment or discolouration of the blade
bar. Make sure that there is always
oil flowing onto the chain.
The oil flows to the blade bar (5) as
soon as the chain starts running.
• Check the oil level regularly and
top up with oil if the level is low.
Tank capacity: 190 cm³ (0.19 l)
• Use bio chain oil containing addit-
ives to reduce friction and wear. Al-
ternatively, use chain lubricating oil
with a low proportion of adhesion
additives.
• Empty the oil tank if it will not be
used for a prolonged period of time
(6–8 weeks).
Procedure
1. Place the tool on its side with the
fuel cap (12) facing upwards.
2. Unscrew the fuel cap (12).
3. Pour the bio chain oil into the tank.
4. Wipe away any spilt oil.
5. Screw the fuel cap (12) on.
50
Inserting and removing the
battery
WARNING! Risk of injury due to
unintentional start-up. Only insert the
batteries into the tool once the tool is
fully prepared for use.
NOTICE! Risk of damage! An incor-
rect battery can damage the tool and
battery.
Inserting the batteries
1. Push the two batteries (17) along
the guide into the battery holder
(10).
You will hear the batteries click in-
to place.
Removing the batteries
1. Press and hold the battery release
(16) on the battery (17).
2. Pull the batteries out of the battery
holder (10).

Switching on and off

Requirements
• The blade bar (5), saw chain (6)
and sprocket cover (9) are correctly
fitted.
• Sufficient chain oil in the tank.
Top up with chain oil if necessary
(Pouring in chain oil, p. 50).
• Batteries are fully charged.
• The tool may only be used with
two batteries of the X 20 V Team
series from Parkside.
Procedure
1. If necessary, insert the batteries
(17) into the tool.
2. Release the chain brake by push-
ing the chain brake lever (4)
against the front handle (11).
3. Hold the chainsaw firmly with both
hands, with your right hand on
the rear handle (1) and your left
hand on the front handle (11). Your