GB
MT
Problem
Poor cutting performance
Device has difficulties
running, saw chain jumps
off
Saw chain gets hot,
smoke development
when sawing, discoloura-
tion of the rail
Transport
• Switch off the tool each time be-
fore transport, engage the chain
brake and remove the batteries.
• Cover the blade bar and saw chain
with the chain guard (22) when you
transport the tool.
• Short distances at the place of
work: Carry the tool by the front
handle (11) with the blade bar
pointing backwards.
• Secure the tool against tipping
over during transport (including in
vehicles) to prevent injury, damage
or loss of fuel.
Disposal/
environmental
protection
Empty the oil tank carefully.
Do not dispose of used oil residues in
the sewage system or down the drain.
Dispose of waste oil in an environ-
60
Possible cause
Saw chain (6) incorrectly
fitted
Saw chain (6) blunt
Insufficient chain tension Tensioning the saw chain,
Insufficient chain tension Tensioning the saw chain,
Not enough chain oil
mentally friendly way – take them to
your local recycling centre.
Remove the battery from the device
and recycle the device, battery,
accessories and packaging in an
environmentally-friendly manner.
The symbol of the crossed-out
wheeled bin means that this product
must not be disposed of as unsorted
municipal waste at the end of its use-
ful life.
Directive 2012/19/EU on waste
electrical and electronic equip-
ment:
Consumers are legally obliged to re-
cycle electrical and electronic equip-
ment in an environmentally sound
manner at the end of its life. In this
way, environmentally friendly and re-
source-saving recycling is ensured.
Error correction
Installing the saw chain
and blade bar, p. 56
• Sharpening the cutting
teeth, p. 57
• Running in a new saw
chain, p. 56
p. 48
p. 48
• Checking the oil level
and oil automation
• contact the service
centre.
Waste electrical and electron-
ic equipment (WEEE) must not
be disposed of with domestic
waste.