Gastroback 41409 Bedienungsanleitung Seite 36

1. Switch off the mincer and disconnect the power supply
cable from the mains. Check that the motor has com-
pletely stopped.
2. Take the pusher and the feed pan of the feed chute.
3. Loosen the screw plug on the right side of the mincer by turning it counterclock-
wise until you can take the worm housing out of the motor housing without any
resistance (picture B).
4. Loosen the closing ring by turning it counterclockwise (picture C). If the closing
ring is screwed on too tight you can use the provided spanner to loosen the clo-
sing ring.
5. Take the closing ring of the worm housing and take the accessories (worm,
crossed-blade knife and grinding disc or the sausage filling attachment and the
adaptor disc) out of the worm housing.
note:
If the tools got stuck knock the mincer carefully on a stable cutting board. The grin-
ding disc should be facing up.
Attention:
mincer.
6. Remove meat residues. Operate as described:
Attention:
or use abrasives for cleaning! This will cause discolouration and corrosion and
damage the motor.
7. Wash all parts thoroughly in warm soapy water. Do not use aggressive deter-
gents. Soak parts with desiccated food leftovers a few minutes in warm soapy
water and use a nylon cleaning brush or cleaning sponge for cleaning. Rinse all
parts with running water and dry them accurately.
Ensure that the switch and power cord do not come into contact with
wArning:
water! Should this inadvertently happen, all parts must be completely dry before the
appliance is used again. Never let water or other liquids run into the motor housing.
Never clean the power cord or the motor housing in the dishwasher, poor liquids
over the appliance or douse or dip it in water or other liquids. In case that water or
other liquids ran into the appliance while operating turn STANDBY the appliance
immediately, pull the plug and dry the appliance with a clean cloth.
8. The motor housing must only be wiped clean with a moist cloth. Do not clean
the motor housing under flowing water, nor should it be immersed in water! Do
not use alcohol, benzine, etc.!
9. Grease the grinding disc and knife with salad oil to prevent air corrosion.
36
Be careful not to damage your bench top, the cutting board or the
Never put the motor housing or the accessories in the dishwasher
c