Replacing The Drive Belt (See Fig. F) - Parkside Performance Ppha 20-Li B2 Originalbetriebsanleitung

Turn the planing blade
WARNING! RISK OF INJURY!
Wear suitable protective gloves when
►
changing the planing blades.
NOTE
Do not undo the two hex screws
►
They are used for adjusting the height
of the cutter block. No adjustment is
required if you use the planing blades
sold by the manufacturer. Otherwise,
an imbalance may occur. Use only the
planing blades supplied by the manu-
facturer.
When changing the blade, always
►
replace both blades to prevent an
imbalance.
Unscrew only one blade to start with.
►
This will allow you to use the factory-
mounted second blade for reference
when reassembling later.
Use the supplied open-ended spanner
♦
to undo the 3 fastening screws
little way so that the planing blade
can be moved (see fig. C).
Push the movable cutter block guard
♦
into the slot in the housing.
Push the planing blade
♦
of the clamping element
NOTE
The planing blade
►
ry-bonded with protective lacquer. It is
not necessary to re-bond the blade.
Fit either a new or turned blade in the
♦
reverse order. Make sure that the notch
on the planing blade
tensioning plate groove
Make sure that the planing blade
♦
trudes a little way (approx. 1 mm) from
the cutter block
movable lateral cutter block guard
Carefully turn the cutter block to check
that the planing blade does not scrape
anywhere.
|
10
GB / IE
or replace it
.
a
sideways out
(see fig. D)
may be facto-
slides into the
(see fig. E).
20a
pro-
in the direction of the
.
Also ensure that the clamping element
♦
closes flush to the cutter block
The clamping element
the hex screws
screws can be tightened.
Planing blades
♦
exclusively from the address given
below (see section "Service"). Do not
use planing blades from other manufac-
turers.
Setting the planing blade height
Set the cutting depth to 0 mm.
♦
Check the position of the planing blade
♦
at both ends. Use a flat, straight
object as a guide strip over the plane
sole .
The tip of the planing blade
♦
flush with the surface of the plane sole
The height of the planing blade
♦
be adjusted using the hex key
two hex screws
screws so that the tip of the planing
blade is flush with the plane sole
both sides.

Replacing the drive belt (see fig. F)

RISK OF INJURY!
Always switch the appliance off and
►
remove the battery pack
rying out any work on the appliance.
Remove the screws
♦
drive belt cover
Remove the worn drive belt
♦
Fit the new drive belt
♦
belt wheel first and then turn the drive
belt and pull it onto the large belt
wheel .
Replace the drive belt cover
♦
in place using the screws
.
must lie on
before the fastening
can be purchased
must be
can
via the
. Adjust the two hex
on
before car-
and detach the
.
.
onto the small
and fix it
.
.