SPARX SHARPENER COMMERCIAL Bedienungsanleitung Seite 28

GOALIE SKATES
To watch the How-To video, visit
Goalie risers are only necessary if your skate has a cowling. Goalie
skates without a cowling you may sharpen normally without risers.
If your skate does have a cowling, follow the steps below.
1
INSTALL THE GOALIE RISERS
Align the Anchor Pins (A)
Slots of the Skate Clamp. Once aligned, press down firmly until
you feel the Goalie Risers
2
CONTINUE THE SHARPENING PROCESS
Refer to "Loading a Skate" in the Operation section of the
manual. When adjusting the
graphic in step 3.
3
ADJUST THE GRINDING RING HEIGHT
Refer to "Adjusting the Grinding Ring Height" in the Operation
section of the manual using the figure below as your guide
where the desired contact point is A, contact point B is too
OPERATION
24
sparxhockey.com/howto
of the Goalie Risers to the Anchor
snap into place.
A
Grinding Ring Height, refer the
high and contact point C is too low.
5
CONTINUE THE SHARPENING PROCESS
Refer to "Sharpening Skates" in the Operation section
of the manual.
6
REMOVE THE GOALIE RISERS
Pull up on each end of the Goalie Risers
Skate Clamp.
B
A
C
to remove from the