Werbung
Verfügbare Sprachen
Verfügbare Sprachen
If the indicator tab of the
Alignment Tool
groove on the
Alignment Ring
6
ALIGN USING THE ADJUSTMENT DRIVER
Locate the
Driver Slot
and place your Adjustment Driver in and
begin to adjust your alignment as needed. Turning to the right
moves the Alignment Ring towards the back, while turning to
left moves the ring to the front. Adjust until the indicator tab is
aligned with the groove on the Alignment Ring. End
Mode
by pressing the
c
Alignment
7
REMOVE THE OPTICAL ALIGNMENT TOOL
Press down on the
Clamp Lever
Remove the
Optical Alignment
8
REMOVE THE ALIGNMENT RING
Open the
Glass
Door. The
Carriage
the install position and the sharpener will play a "ready" tone.
While holding the
Grinding Ring
and remove the
Alignment Ring.
9
INSTALL THE GRINDING RING
Grinding Ring Arbor
While holding the
Ring
(B) on the
Grinding Ring Arbor
replace and tighten the
Thumb Nut
the
Glass
Door.
is aligned with the
(as shown below) skip to step 8.
Alignment
Button.
to open the
Skate
Clamp.
Tool.
will automatically move into
Arbor, unscrew the
Thumb Nut
(C), slide the
Grinding
(C), label facing out, and
(A) until hand-tight . Close
C
B
A
SETUP
17
Werbung
