SPARX SHARPENER COMMERCIAL Bedienungsanleitung Seite 26

SHARPENING SKATES USING
KEYPAD
Once you have loaded the skate, closed the
Grinding
adjusted the height of the
sharpening.
To cancel the cycles at any point during the sharpening, press the
n Cancel Button once. This will send the
position at the end of its current pass.
1
BEGIN SHARPENING
Press the p Play Button. Once the button has been pressed, it
will change from white to blue and the sharpening process will
begin.
Upon pressing the p Play Button, the grinding motor will turn on.
The Cycle Counter will flash with the current cycle number until that
cycle (out and in) is completed. The sharpener will continue to run
until all cycles have been performed.
At the completion of the final cycle, the end of sharpening is marked
by a "cycle complete" tone and the case LEDs will turn green.
ADDITIONAL CYCLES
If additional cycles are desired, you can reset the cycle count and
press the p Play Button again.
If the Grinding Ring skips when it first makes contact
with the blade, the Grinding Ring's height is too high.
When properly set, the Grinding Ring should make a
smooth transition onto the skate blade.
OPERATION
22
Slot Covers, and
Ring, you are ready to begin
Carriage back to its home
UNLOADING A SKATE
1
DISENGAGE SLOT COVERS
Move both Slot Covers (A) away from the skate.
A
2
REMOVE THE SKATE
Press and hold down the Clamp Lever
Clamp. Remove the skate from the
Clamp Lever.
A
to open the Skate
Skate Clamp and release the