Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4
ADJUST THE GRINDING RING HEIGHT
Open the
Glass
Door. Locate the red
Knob
(A). Pull the knob towards you to raise the height or push
away from you to lower the height until the
at the desired height. The knob is labeled 1-8, with 8 being the
highest setting for the
Grinding Ring
setting.
A
5
INSPECT THE CONTACT POINT
U
sing the
l
Left
and r
Right
Ring
to the skate blade. Inspect its contact point and be sure
it is in its desired position. Repeat steps 4 and 5 until the
Grinding Ring
makes contact at the desired position.
6
END MOVE MODE
Press the
m
Move Button
again to send the
to its home position.
h
Height Adjustment
Grinding Ring
is
and 1 being the lowest
Buttons, touch the
Grinding
Grinding Ring
back
SELECTING THE NUMBER
Of CYCLES WITH KEYPAD
When the sharpener moves the
Grinding Ring
skate blade once, it is called a cycle.
Typically when adjusting cycles, you control the sharpener using the
Sparx Hockey App but it is possilbe to adjust the cycle count with
the Keypad.
When sharpening your first pair of skates, we recommend
sharpening with six cycles. This allows the Sparx BEAM
an accurate reading on the alignment of your sharpener.
We have found that four cycles will handle normal wear and tear
(and even small nicks) from one to four hours of skating between
sharpenings. For brand-new steel or when changing
hollow depths, we recommend using ten cycles to ensure you
completely reset the skating surface of the blade.
1
ADJUST THE CYCLE COUNT
Use the
Left
and
Right Buttons
adjust the number of cycles desired. The number of cycles
selected will be illuminated on the
out and back over the
to give you
TM
Grinding Ring
(A) on the
Keypad
to
Cycle Counter
(B).
B
A
OPERATION
21
Werbung
