SPARX SHARPENER COMMERCIAL Bedienungsanleitung Seite 15

ASSEMBLING THE SHARPENER
To watch the How-To video, visit
1
PLACE SHARPENER
Place the sharpener on a sturdy, level surface. Locate the
sharpener so that the vacuum hose can be connected easily
from the sharpener to the vacuum system.
2
INSTALL THE CLAMP LEVER
Slide the Clamp Lever (A) onto the
lever down until it clicks into place. When the
engaged, it will lay at a slight angle.
A
B
3
REMOVE THE TRAVEL GUARD
Open the Skate Clamp by pressing and holding down the
Clamp Lever. Remove the Travel
sparxhockey.com/howto-pro
Lever Dock (B). Press the
Clamp Lever
is
Guard. Release the Clamp Lever.
4
PLUG IN THE POWER CORD
Plug the Power Cord (A) into the
side of the sharpener. Plug the other end into a wall outlet.
Power Input Port
Toggle the switch on the
(I=on, 0=off).
B
A
Transporting or moving the Sharpener without the
Travel Guard installed voids your Warranty and/or
Extended Service Plan. Always remove the Travel
Guard before operating the Sparx Sharpener.
Power Input Port (B) on the
to the on position
SETUP
11