Vermeiren Inovys Gebrauchsanweisung Seite 16

E
Note the following before inserting the new inner tube:
Check the rim bed and the inside wall of the tyre for foreign matter and clean these properly if
necessary. Check the condition of the rim bed, especially around the position of the air valve. Please
use only genuine original replacement parts. We do not accept any liability for damage caused by non-
genuine parts.
Check all around on both sides that the tube is not pinched between the rim and the edge of the tyre.
Lightly push the air valve inwards and pull it out again to make sure that the tyre is positioned properly
in the region of the air valve.
To ensure that the wheel is inflated correctly, admit only so much air initially that the tyre can still be
easily pushed inwards by using your thumbs. If the check-lines are equi-distant from the edge of the
rim on both sides of the tyre, then the tyre is centred properly. If not - let out the air and position the
tyre afresh.
Now the tyre can be inflated to its full operating pressure (note the maximum!!) and the valve cap
should be replaced.
L
Only an expert can guarantee correct assembly. Work not done by your specialist dealer,
would void any warranty claims.
L
When mounting a tyre, make sure that no objects or body parts are pinched between the tyre
and the rim, since that could cause damage and/or injury.
L
When inflating the tyres, always check that the pressure is correct. The correct pressure is
given on the tyre walls (refer also to the section "Specifications").
L
Use only inflating equipment which complies with regulations and indicates the pressure in
bar/kilopascal, or use the supplied air pump. Damages resulting from the use of unsuitable
inflating equipment are not subject to the warranty.
Place the rim belt in position over the air valve before inserting it into
the rim. Then the rim belt can be pulled over easily. Check that all
spoke heads are covered (a rim belt is not required in the case of a
plastic rim).
Push the tyre over the edge of the rim, starting behind the air valve.
Inflate the tube slightly until it is round, and place it inside the tyre.
If the tube fits snugly inside the tyre without any folds (in the case of
folds: let out some air), then the upper side of the tyre can be pressed
lightly onto the rim with both hands, starting at the air valve.
16
INOVYS
06/2008