Pkm WT8+5-TC-AD Bedienungsanleitung Seite 164

9.1 Checklist
POSSIBLE CAUSE(S)
1. The plug of the appliance is not
connected to the socket.
2. The plug has become loose.
3. The socket is not supplied with
energy.
4. The fuse is switched off.
5. The voltage is too low.
1. Door is not closed properly.
2. No water supply.
3. S / P
TART AUSE
4. O / O button
N FF
1. Heater defective.
1. Connection of the hoses are not
watertight.
2. Drain pump / drain pump filter is
blocked.
3. Water drain hose is dirty.
1. No energy supply.
2. Circuit board damaged.
3. Wiring harness damaged.
Depending on model.
64
MALFUNCTION
T
HE APPLIANCE DOES NOT WORK AT ALL
T
HE SET PROGRAMME DOES NOT START
button is pressed.
is not pressed.
64
F
AULTY HEATING
W
ATER LEAKAGE
I / D
NDICATORS
~
MEASURE(S)
1. Connect the appliance to the mains
properly.
2. Check the plug.
3. Check the corresponding socket by
connecting it with another appliance.
4. Check the fuse box.
5. Compare the data on the model plate
with the data of your energy supplier.
1. Close the door properly.
2. Check the water supply.
3. Check your settings.
4. Press the O
.
1. The appliance can wash but not heat.
Please contact your aftersales service
immediately.
.
1. Check the hoses.
2. Check the drain pump / drain pump
filter.
3. Clean the water drain hose.
ISPLAY DO NOT WORK
1. Check the energy supply.
2. Please contact
service.
3. Check the wiring harness (please
contact your aftersales service if
necessary).
~
164
.
.
/ O button.
N FF
.
your aftersales