9. When the programme is finished, always turn the
selection back to « O
chapter 5.5 E
ND OF A WASHING
10. Close the water tap.
11. It is very important to check the water level and water temperature inside the
drum before opening.
12. You can open the door.
If the door lock will not be released and the door cannot be opened, the
temperature inside the washing drum is more than 50 °C or the current washing /
drying programme has progressed too far.
NOTICE! It is not possible to open the door while the door lock indicator is
on. Do not open the door by force. To open the door by force can damage
the appliance seriously. RISK OF DAMAGE!
NOTICE! Any damage to the appliance and / or the door caused by
forcible opening of the door are not subject to the guarantee or the
warranty!
NOTICE! If there is a lot of foam or water in the drum, open the door very
carefully. Use a dry cloth to prevent foam and / or water from leaking out
of the drum while the door of the appliance is opened.
5.5 End of a washing / drying programme
When a programme has finished, the time display indicates « END » and an
acoustic signal sounds.
The door lock is deactivated after approx. 2 minutes.
All drying programmes end with cooling down period.
1. When the programme is finished, the display indicates « END » and an acoustic
signal sounds.
2. The door lock is deactivated automatically after approx. 2 minutes. The
operational status indicator of the door lock «
3. When the programme is finished, always turn the
selection back to « O
4. Close the water tap.
5. Open the door and remove the laundry.
6. Leave the door and the detergent dispenser slightly opened, so the moisture can
escape completely.
» to switch off the appliance completely (see also
FF
/
DRYING PROGRAMME
» to switch off the appliance completely.
FF
~
146
ROTARY KNOB
).
» goes off.
ROTARY KNOB
~
for programme
for programme