ZUMEX Essential Basic Bedienungsanleitung Seite 34

2
Fit the Elevation Kit legs.
There are four holes on the base of the machine, where the legs go. The legs
are supplied with some screw-in studs that are already fitted into the ends
of the legs. We must fully insert them into the holes (A) on the base and then
screw the legs in as far as they will go. Once this operation has been carried
out with all four legs, these can be mounted and removed when required
without the screw-in studs coming out of their housing.
3
Put the machine back into its working position.
Carefully stand the machine back up again leaving it in its working position.
A