ZUMEX Essential Basic Bedienungsanleitung Seite 30

Essential Basic, Essential Pro
6
Remove the blade holder (Fig. 7) by pulling it towards you using the handle.
WARNING!
7 Pull the ejectors out until it is completely free from the machine (Fig. 8). To
assemble them again, place the ejectors on the corresponding side and insert
them onto the knobs. Push the ejector until the blade is fully inserted into the
lower pressing unit and the channel makes contact with the second knob.
Important: Remove the ejectors before removing the pressing units of the
!
juicer. If the ejector is not correctly installed as indicated above, the part may
be damaged when the machine is in operation.
Remove the pressing units in pairs, after having unscrewed the knobs that hold
8
them in place (Fig. 9).
Versatile Pro
Remove the 1Step Kit (Fig. 15-16) from the machine. First, check the assembly
6
and disassembly instructions in the following section 1Step Extraction Kit.
There are two possibilities when cleaning:
• Complete cleaning: once the unit has been removed from the machine,
get rid of extra pulp and peel if there is any washing it with water and if
necessary a mild soap. The whole unit is also dishwasher safe.
• Deep cleaning: all of the components can be removed and can be cleaned
individually. Zumex recommend this type of deep cleaning at least once a
week depending on how much usage the machine gets.
Remove the Blade holder (9) and clean it carefully taking care not to hurt
7
yourself.
• The plastic parts of the squeezing system are suitable for cleaning in a dishwasher.
handle this piece very carefully as you could cut yourself.