Dreame BotW10 Benutzerhandbuch Seite 26

Errors
If the base does not work properly, an error icon and message will be displayed on the
display screen. Read the message and handle the issue based on the following table.
Error Icon
Insufficient Water in Fresh
Tank
Fresh Tank Not Installed
Waste Tank Not Installed
Washboard Not Installed
Abnormal Washboard Water
Level
Robot Malfunction
FAQ
Problem
The robot will not turn
on.
The robot will not
charge.
The robot will not
return to the base.
The robot is
malfunctioning
The robot is making a
strange noise.
The suction power is
Error Message
Solution
The battery is low. Recharge the robot on the base and try
again.
The ambient temperature is too low (below 0°C) or too high
(above 40°C). The operating temperature of the robot is 0°C to
40°C.
The base is unplugged. Makes sure that both ends of the
power cord are plugged in.
Poor contact. Wipe the charging contacts of the base and
robot.
There are obstructions around the base. Please the base in a
more open area.
Wipe the signalling area of the base.
Moving the robot may cause it to re-position itself or re-map its
surrounding. If the robot is too far from the base, it might not
be able to automatically return to the base, in which case you
need to manually place the robot onto the base.
Turn off the robot and then restart it.
The main brush, side burh, or main wheels may be entangled
with hair or debris. Turn off the robot and remove any hair or
debris.
The dust bin is full. Empty the dust bin.
Solution
Add a sufficient amount of water to the
fresh tank.
Put the fresh tank in place.
Put the waste tank in place Empty the
wastewater.
Check whether the washboard is installed
and whether the clips on both sides of
the washboard are in place.
Check whether the waste port is clogged.
If yes, clean it.
Check whether and exception occurs to
the robot. Please refer to the "FAQ"
section in this manual for
troubleshooting.
26