Shark POWERDETECT RV2820VEEU Serie Gebrauchsanweisung Seite 6

IMPORTANT: Be sure to charge the robot completely before its first cleaning so that it can explore, map, and
clean as much of your home as possible. It may take up to 6 hours to fully charge your robot.
To TURN THE ROBOT ON: Place the robot on the
Self-Empty Base or hold down DOCK button for 5
to 7 seconds, until the indicator lights turn on.
NOTE: When manually placing the robot on the Self-Empty Base, make sure the Charging Contacts on the bottom of the
robot are touching the ones on the base.
NOTE: When picking up the robot, be careful not to place fingers between the bumper and the back of the robot.
s h a r kc l e a n . e u
CHARGING
When the cleaning cycle is complete, or if the battery
is running low, the robot will search for the Self-
Empty Base. If the robot doesn't return to the base,
its charge may have run out.
DOCK AND CLEAN BUTTONS
CLEAN BUTTON
If the robot is on the base,
press the CLEAN button for
a whole-home clean. Press
again to pause the cleaning
session.
DOCK BUTTON
To turn on/off your robot,
press the DOCK button for
5-7 seconds.
Press the DOCK button to
allow the robot to go back to
the Self-Empty Base.
RECHARGE & RESUME
Press and hold the DOCK
button for 15 seconds to turn
Recharge & Resume ON or
OFF.
The Recharge & Resume function is turned ON
by default. The robot will run until it reaches low
battery, and if its cleaning mission is not complete,
it will return to the base, recharge, and pick up
where it left off.
s h a r kc l e a n . e u