Shark POWERDETECT RV2820VEEU Serie Gebrauchsanweisung Seite 10

MAINTENANCE
CLEANING THE ROBOT'S FILTER
For optimal suction power, after each use, clean the filter inside the robot's dust bin.
Remove and empty the dust bin. Clean any hair or
debris off the back of the dust bin.
CLEANING THE SENSORS AND CHARGING CONTACTS
THE SENSORS ON THE ROBOT REQUIRE OCCASIONAL MAINTENANCE. With a dry cloth or cotton swab,
gently dust off the sensors located on the bottom and sides of the robot.
IMPORTANT: The robot uses cliff sensors to avoid stairs and other steep drops. Sensors may work less effectively when
they are dirty. For best results, clean sensors regularly.
s h a r kc l e a n . e u
Every time you empty the dust bin, lightly tap dust
and dirt off the filter, then use a dry cloth or soft
brush to remove any remaining debris.
MAINTENANCE
CLEANING THE WALL-FOLLOW SENSORS
1. The sensors on the robot require occasional maintenance.
2. With a dry cloth or cotton swab, gently dust off the sensors located on the sides of the robot.
CLEANING SIDE BRUSH
CLEAN SIDE BRUSH AS NEEDED.
NOTE: Remove and replace any side brush that is bent or damaged. To remove a brush, lift it off its peg.
Carefully unwind and remove any string or hair
wrapped around brush.
Gently wipe brush with a dry cloth. To reinstall, snap
the brush over the peg. Spin the brush manually to
make sure it is installed correctly.
s h a r kc l e a n . e u