Shark POWERDETECT RV2820VEEU Serie Gebrauchsanweisung Seite 12

MAINTENANCE
LIDAR MODULE
CLEANING THE WHEELS
CLEAN FRONT WHEEL HOUSING PERIODICALLY.
See sharkaccessories.com for replacement parts.
Rotate the front wheel while lightly brushing away
dirt and debris. Clean the wheel and the housing
around it.
NOTE: Brush not included.
s h a r kc l e a n . e u
Check the navigation module on top of the robot
and gently remove any hair or debris. For a more
complete clean, place the robot on a level surface
and turn off the power. Use compressed air to
blow away any dirt or debris from the gap around
the rotating LiDAR module. You may also clean by
rotating a cotton swab in both directions.
Periodically clean the drive wheels and the housing
around them. To clean, rotate each drive wheel
while dusting.
REPLACEMENT PARTS
CLEANING THE DIRTDETECT SENSORS
Remove the robot dust bin. Using the included
DirtDetect brush or a microfiber cloth, wipe off
the area indicated to remove any dust or debris
covering the sensor.
NOTE: To order replacement parts visit sharkaccessories.eu
REPLACEMENT PARTS: ROBOT
Robot Dust Bin Brushroll*
Side Brush* Self-Empty Base Robot Dust Cup
Filter
*NOTE: Design may vary.
Battery Brushroll Door* Odour Cartridge
Assembly
Dock Pre-Motor
Dock Post-Motor
Filter
Filter
s h a r kc l e a n . e u