Switch The Machine On And Off; Cleaning, Maintenance, Storage, Disposal; Cleaning; Maintenance - Zipper Zi-Rwm827-Lcd Betriebsanleitung

9.
Press key and
indicator balance position on both sides lights up
Mark the 9 o'clock position with chalk on rubber.
10. Remove the wheel from the machine. Use a tyre
changer and change the rim and rubber to make
the markings match. Remount the wheel on the
machine
11. Put down the hood. Press key
cycle starts. Comes
15.7

Switch the machine on and off

16

CLEANING, MAINTENANCE, STORAGE, DISPOSAL

Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or
death.
 Always disconnect the machine from the power supply before cleaning,
maintenance or repair work and secure it against unintentional reconnection.
16.1

Cleaning

Regular cleaning guarantees the long service life of your machine and is a prerequisite for its safe
operation.
Incorrect cleaning products can attack the finish of the machine. Do not use any
solvents, nitro thinners or other cleaning products that could damage the machine's
finish.
Observe the specifications and instructions of the cleaning agent manufacturer.
After each use, remove dust and dirt particles from the machine.
•
Clean the machine with a damp cloth and, if necessary, some commercial detergent or
•
blow it out with compressed air at low pressure.
• Lubricate bare machine parts with an acid-free lubricating oil (e.g. WD40 rust inhibitor).
16.2

Maintenance

The machine is low-maintenance and only a few parts need to be serviced. Malfunctions or defects
that could affect your safety must be repaired immediately!
Before each operation, check the perfect condition of the safety devices.
•
Regularly check the perfect and legible condition of the warning and safety labels of the
•
machine.
Use only original spare parts recommended by the manufacturer.
•
ZIPPER MASCHINEN GmbH
to rotate the wheel till one
=> measuring
Switch on
• Set ON-OFF switch to position ON (I).
Switch off
• Set ON-OFF switch to position OFF (0).
W A R N I N G
www.Zipper-Maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
N O T E
If unbalance is less than
before, OPT succeed
ZI-RWM827-LCD
46