Static Mode; Alu Mode - Zipper Zi-Rwm827-Lcd Betriebsanleitung

15.5.2

Static mode

In contrast to dynamic mode, where weights are applied to both the inside and outside plane of
the rim, static balancing of a wheel requires only a single weight to be applied to one position on
the rim.
Static balancing is suitable for wheels with a small width, since the unbalance increases as the
width of the wheel increases.
Perform a measuring cycle in static mode
•
Add a counterweight on the middle of rim in 12 o'clock position
•
Check the result
•
15.5.3

ALU mode

Same operation for ALU-1, ALU-2, ALU-3, ALU-4, ALU-5. Only the position to add counterweights is
different
• Input values a (rim distance), b (rim width) and d (rim diameter)
(see chapter "Dynamic mode")
Switch the machine on
•
• Press key till the required ALU-mode indicator lights up
• Put down the hood. => measuring cycle starts.
• The unbalance values remain on the screen after finishing the measuring cycle.
• Press key may check the real unbalance value under threshold
ZIPPER MASCHINEN GmbH
•
•
•
Check the result:
•
•
•
www.Zipper-Maschinen.at
Press key or find the unbalance position
outside automatically.
All indicators of outside unbalance position lights up
green
Add the counterweight on the outside 12 o'clock
position
Put down the hood. => measuring cycle starts.
If 0 0 is displayed, the result is OK
If the result is not satisfactory, repeat the balancing
process
• All indicators of inside unbalance
position lights up green
Add the counterweight on the inside 9
•
o'clock position
OPERATION
41
ZI-RWM827-LCD