Alu-S Mode - Zipper Zi-Rwm827-Lcd Betriebsanleitung

15.5.4

ALU-S mode

This mode is used for special rim.
If ALU-1, ALU-2, ALU-3, ALU-4, ALU-5 can not be used, you should choose ALU-S mode.
Switch the machine on
•
NOTE: Counterweights for reference only. Exact
positions follow below.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
Press key or
•
position outside automatically.
• All indicators of outside unbalance
position lights up green
Add the counterweight on the outside 9
•
o'clock position
Check the result:
Put down the hood. => measuring cycle
•
starts.
If 0 0 is displayed, the result is OK
•
• If the result is not satisfactory, repeat the
balancing process
Input value aI:
Move gauge head (1) to touch the rim
•
edge for appr. 4s as shown
Input value aE:
Move gauge head (1) to touch the rim
•
edge for appr. 4s as shown
After a beep, the values of aI and aE are
saved and the system switches to ALU-S
mode (the values of dI and dE are measured
automtically)
Manuel Input (if needed):
Press key and
values
OPERATION
find the unbalance
or to input the
ZI-RWM827-LCD
42