Assembly; Preparation; Check Delivery Content; Requirements For The Installation Site - Zipper Zi-Rwm827-Lcd Betriebsanleitung

14

ASSEMBLY

14.1

Preparation

14.1.1

Check delivery content

Check the delivery immediately for transport damage and missing parts. Report any damage or
missing parts to your dealer or the shipping company immediately. Visible transport damage must
also be noted immediately on the delivery note in accordance with the provisions of the warranty,
otherwise the goods are deemed to have been properly accepted.
14.1.2

Requirements for the installation site

The selected installation site must ensure a suitable connection to the power supply.
Place the machine on a level, solid surface.
The space requirement by the machine including a distance of approx. 60 - 100 cm to walls and
other objects result from the technical data (dimensions, weight) of your machine. When
dimensioning the required space, take into account that an unobstructed air supply to the
machine must be ensured and that the operation, maintenance and repair of the machine must
be possible without restrictions at all times.
The chosen installation site of the machine must comply with the local safety regulations as well as
the ergonomic requirements for a workplace with sufficient lighting conditions.
14.2

Assemble

The machine comes pre-assembled, it is necessary to assemble the components dismantled for
transport according to the following instructions and to make the electrical connection.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
• The base of the machine has fastening holes by
means of which the machine is firmly connected
to the ground. This prevents movement of the
machine during operation and possible damage or
injury.
• Adjust the height of the stabilizer foot
• Required fixing material is not included in the
scope of delivery.
1. Hood rod support
• Mount the hood rod support (1) on the backside of
the machine as shown
2. Hood rod
• Guide the cable of the rim width gauge (5) through
the shaft (2) of the hood rod support
• Slide the hood rod (1) onto the shaft (2)
• Position the bracket so that the fixing holes aligned
exactly to each other
• Fix the bracket with screw M8x45 (3) and nut M8 (4)
• Make the plug connection (6)
ASSEMBLY
31
ZI-RWM827-LCD