Handling; Mounting The Wheel - Zipper Zi-Rwm827-Lcd Betriebsanleitung

15.4

Handling

15.4.1

Mounting the wheel

Clean thge wheel
•
• Take off old counterweights and check pressure of wheel
Choose the way of mounting according to the type of wheel.
•
In the following alternative methods for a quick mounting of the wheel using the quick release nut are
described.
15.4.1.1. Back centering cone mounting
The majority of steel rims can be mounted using this method.
15.4.1.2. Front centering cone mounting
A wheel should only be mounted using this method if the inner surface of the rim does not provide a
firm grip.
ZIPPER MASCHINEN GmbH
• Select the correct size of the centering cone diameter.
• Place the centering cone on the threaded shaft and
NOTE:
not slide back and forth with the center bore of the rim
on the threaded shaft. The threaded shaft can be
damaged over time.
• Make sure that the pressure cup is attached to the
• Select the centering cone that best corresponds with
• Slide the centering cone with the larger diameter
• Lift the wheel onto the threaded shaft. Make sure that
• Mount the quick release nut with the pressure cup
• Make sure that the pressure cup is NOT attached to the
• Slide the wheel onto the threaded shaft. Make sure
• Select the appropriate centering cone for the center
• Place the quick release nut WITHOUT pressure cup
www.Zipper-Maschinen.at
This ensures a secure fit of the rim on the threaded
shaft.
partially through the center bore of the rim.
Carefully place the rim on the threaded shaft. Do
quick release nut.
the diameter of the center bore of the rim.
towards the flange on the threaded shaft; the smaller
diameter is facing the center bore of the rim
the inner side of the rim is in contact with the flange
and the centering cone.
onto the threaded shaft. Tighten the quick release nut
firmly towards the rim. The quick release nut should
engage the threads for at least three full turns.
NOTE: To protect the rim, use a nylon spacer between
the rim and the pressure cup.
quick release nut.
that the inner side of the rim is in contact with the
flange.
bore and slide it onto the threaded shaft with the
smaller diameter towards the flange.
NOTE:
It is necessary to lift the wheel to insert the
centering cone into the centre hole to avoid damaging
the thread shaft.
onto the threaded shaft. Tighten the quick release nut
firmly towards the rim with at least three full turns.
OPERATION
38
ZI-RWM827-LCD