Werbung
EN
32
TROUBLESHOOTING
Fault
Light on, but motor does
not work.
Light does not work,
motor does not work.
Oil leakage.
The suction power is
insufficient.
The Cooker hood
inclines
Notes:
Any electrical repairs to this appliance must conform to your local, state and
federal laws. Please contact the service centre if in any doubt before undertaking
any of the above. Always disconnect the unit from the power source when opening
the unit.
Possible Cause
Fan switch turned off
Fan switch failed
Motor failed
House fuses blown
Mains power cable is
loose or disconnected
One way valve and the
outlet are not tightly
sealed
Leakage from the
connection of chimney
and cover
The distance between
the cooker hood and the
gas top is too far
The fixing screw is not
tight enough
Solution
Select a fan switch
position.
Contact service center.
Contact service center.
Reset/Replace fuses.
Refit mains power cable
to power outlet.
Take down the one
way valve and seal with
sealant.
Take chimney down and
seal.
Refit the cooker hood to
the correct distance.
Tighten the hanging
screw and make it
horizontal.
Werbung
