Bolt Setting - HASE Bikes Lepus Gebrauchsanweisung

Bolt torque setting
Spokes:
If spokes become loose or one of the wheels does not run true, the
wheel must be aligned.The front wheel can be aligned like any "normal"
wheel in a centering gauge or in the fork.
The rear wheels should not be removed for alignment!
If at any time the wheel is to be aligned in situ / place (frame or fork), it
is recommended that an alignment guide be used.
This could be, for example, an old spoke clamped to the mudguard and
bent to the rim. This way any deformation of the wheel can be pin-
pointed.
Bolt torque settings
The torque settings are determined according to specifications (Dubbel).
A torque wrench should be used when tightening.
Bolt quality 8.8
The M14 axle bolt only needs to be tightened lightly as it is tightened
further automatically by the drive torque.
Before commencing any journey, check the bolts for tightness.
M5 5.5
M6 9
M8 23
M10 46
M12 79
Nm
Nm
Nm
Nm
Nm
40