en
Changing over the
door hinges
(If required)
Carefully place the appliance on its back.
Proceed in numerical sequence:
Fig. 1 Single door appliance
Fig. 2 Two door appliance
If the appliance features a door switch:
Insert the open door into the door bearing,
Fig. 3/A.
Important! Door pin B" must be situated
in front of the door switch C".
10
Changing over the
door handles
Lever handles
Fig. 4
Installation in numerical sequence.
A Torx T 20 screwdriver is required.
S Lift off the cap 1 with a knife.
S Unscrew screw 2.
S Pull out stop 3.
S Remove handle 4
S Unscrew sheet metal plate 5
S Using two knives, remove the stoppers
6 opposite the door handle and
reposition on the opposite side.
S Laterally reverse the sheet metal plate
7 and attach to the opposite side.
S Insert clip 8 into the handle.
S Push handle 9 onto the
sheet metal plate.
S Screw on the handle and attach
the cap AT.
S Attach the stop AK.