Herunterladen Inhalt Inhalt Diese Seite drucken

Installation; Electrical Connection; Changing Over The Door Hinges - Siemens KGM Serie Aufstell- Und Umbau-Anweisung

Vorschau ausblenden Andere Handbücher für KGM Serie:
Inhaltsverzeichnis

Werbung

Before reading the instructions, turn to
the illustrations on the last page.
We use recycled paper as our
contribution to protection of the
environment.

Installation

S Install your fridge freezer in a dry,
well ventilated room. In a damp room
the humidity in the air would form
condensation on the outside of
the appliance.
S If the appliance is placed next to a heat
source or another refrigerator, observe
the minimum lateral distance, otherwise
use a suitable insulating plate:
- from an electric cooker
- from an oil or solid fuel cooker
- from a refrigerator
S The air heated on the rear panel of the
appliance must be allowed to escape
unhindered. Therefore, never block
the ventilation openings.
S The appliance must stand firmly on
the floor and must be level. If the floor is
uneven, use the height adjustable feet,
Fig. 1. The two rollers which are
attached under the appliance at the rear
facilitate movement of the appliance
to its installation location.
S If the refrigerator is installed in such
a way that the door opens onto a side
wall, the appliance should be installed
at a distance of 12 mm from this wall.
The drawers can then be taken out.

Electrical connection

S Connect the appliance only to a
220 240 V alternating current (50 Hz,
10 amp fuse) via a correctly installed
earthed socket.
Changing over the door
hinges
We recommend that you have the door
hinges changed over by our customer
service.
Before you start the conversion work,
pull out the mains plug or remove the
fuse. Never pull out the mains plug
by tugging the cable.
3 cm
Fig.2
30 cm
S Remove the base rim (5). To do this,
2 cm
pull outwards and then forwards first
on the left side and then on the right
side. Insert stopper (6) on the opposite
side of the base rim.
S Unscrew the pin (8) out of the lower
hinge (7) (open end wrench A/F 8).
Remove bearing bush and spacer
ring and keep in a safe place!
Remove freezer compartment door (1).
S Remove the cap (16) from the upper
hinge of the refrigerator compartment
door (2).
S Open the refrigerator compartment door
(2) and remove the panel (14). Pull out
the plug (13). Close the door again.
de
en
5

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis