Bail Handles; Angular Handles; Installation - Siemens GS28K4F3/03 Montageanleitung

Bail handles

Fig. 5
S Lift out the cover 1 with a knife and
unscrew the handle on the left side.
S Lift off the stopper 2 opposite the door
handle with two knives and reposition
on the opposite side.
S Pull the handle all the way in the
direction of the arrow 3.
S Carefully pull the handle in the direction
of the arrow 4, the handle disengages
from the centre attachment.
S Pull the handle out of the centre
attachment 5.
S Reposition the handle and re insert into
the centre attachment 6.
S Push the handle all the way in the
direction of the arrow 7.
S Screw the handle 8 to the right side.
S Insert the stopper 9.

Angular handles

Fig. 6
Installation in numerical sequence.

Installation

Install the appliance in a dry, well
ventilated room. But not in direct sunlight
and not near a heat source, e.g. cooker,
radiator, etc. If installation near a heat
source is unavoidable, use a suitable
insulating plate or observe the following
minimum distances to a heat source:
3 cm to an electric cooker.
30 cm to an oil or solid fuel cooker.
Appliances with fitted handles must be
situated at least 55 mm from the wall on
the hinge side so that the door can be
opened by 90°. Fig. 7
Removing stickers
Remove any stickers from the outside
of the appliance. To remove adhesive
residue, dab several times with the
adhesive side of the sticker.
Do not scrape off adhesive residue with
sharp edged metal objects. Remove
stubborn adhesive residue with cleaner's
naphtha. Do not use solvents
(e.g. nail varnish remover).
Insert wall spacers (if enclosed) into
the ventilation grille. Fig. 8
The height adjustable feet have been
screwed in all the way at the factory.
When installing the appliance, unscrew
the height adjustable feet, Fig. 9 by
an initial 5 mm. Place the appliance in
the designated location and align.
Adjust the height adjustable feet with
a screwdriver.
en
11