Installing The Reserve Parachute - Advance SUCCESS 2+ Betriebshandbuch

Caution: Always have the complete foam protector installed
in its compartment. Only then can you be sure that it will not
slip out of place in the event of a crash.
Caution: Only use the original dual-chamber foam protector

Installing the reserve parachute

The SUCCESS 2+ reserve stowage is located in an aerodynamically
efficient place, close to the pilot's centre of gravity.
The harness/reserve bridle runs in a special channel at the side of the
harness. This channel is closed with a zip-fastener. Even after long
periods without use this opens easily and reliably.
To close the channel slide the zip slider carefully from the top in its
opposite direction to the lower end, to the beginning of the zip. The
channel can now be smoothly closed with the zip. Stow the zip slider
in its special 'garage'.
The correct stowing of the parachute is not complicated, but this
must be done carefully and accurately – the pilot's safety depends on
it. If you are not sure how to do this do not hesitate to contact some-
one with appropriate experience, or your ADVANCE dealer!
08354600_Advance_Success2+ 48
48
10.07.2008 10:36:10 Uhr