Scheppach PM1600 Originalbetriebsanleitung Seite 28

- Up to three waste electrical devices per type of
device, with an edge length of no more than 25
centimetres, can be returned free of charge to
the manufacturer without prior purchase of a new
device from the manufacturer or taken to another
authorised collection point in your vicinity.
- Further supplementary take-back conditions of
the manufacturers and distributors can be ob-
tained from the respective customer service.
• If the manufacturer delivers a new electrical appli-
ance to a private household, the manufacturer can
arrange for the free collection of the old electrical
appliance upon request from the end user. Please
contact the manufacturer's customer service for
this.
• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Un-
ion, different regulations may apply to the disposal of
waste electrical and electronic equipment.
15. Troubleshooting
Problem
Motor does not start.
Unusual vibrations
The device starts up, but
blocks when the load is
low and may switch off
automatically.
28 | GB
Possible cause
No power supply (power failure)
Mains cable defective.
Motor or switch faulty.
Beater defective.
Chuck defective.
Non-intended material to be mixed.
Extension cable too long, or cross-
section too small.
Socket too far away from main
connection, and cross-section of
connection lead too small.
www.scheppach.com
Remedy
Check fuses
Exchange defect cable, respectively
check extension cable, (by electrician)
Never use defect lead
To correct the problem, refer to the manu-
facturer or other approved service centre.
Replace the beater.
To correct the problem, refer to the manu-
facturer or other approved service centre.
Incorrect processing. Follow the process-
ing instructions from the supplier.
Extension cable at least 1,5 mm
mum 25 m long.
Cross- section of at least 2,5 mm
longer cables.
, maxi-
2
in
2