Scheppach PM1600 Originalbetriebsanleitung Seite 26

Observe the following to maintain the operability of the
machine:
• Keep vent slits clean and free from obstructions.
• Remove dust and dirt using a cloth or a soft brush.
• Do not clean the machine with running water or high-
pressure cleaners.
• Do not use solvents for the synthetic parts (petrol,
alcohol, etc.) as these can damage the synthetic
parts.
• Clean the beaters.
• The agitator is equipped with carbon brushes. Have
the carbon brushes be replaced by the customer
service if they are worn
Regularly check the beater for damages for your own
safety. Immediately replace any damaged beater. Al-
ways replace the beaters in pairs.
Check the shaft on a regular basis. An agitator with de-
fective shaft must no longer be used. Have the device
be repaired by the customer service.
11. Repair & ordering spare parts
After any repair or maintenance work, make sure that
all safety-related parts are in place and in perfect con-
dition. All parts which may cause injury must be kept
where they are inaccessible to children or others.
Attention: According to the German Product Liability
Act, no liability is accepted for damage caused by im-
proper repairs or by not using original spare parts.
Such work should be performed by a customer service
centre or an authorised specialist. The same applies to
accessory parts.
Connections and repairs
Connections and repair work on the electrical equip-
ment may only be carried out by electricians.
11.1 Ordering spare parts
Please provide the following information when order-
ing spare parts:
• Model designation
• Article number
• Type plate data
26 | GB
Spare parts / accessories
Carbon brushes
Mixer rod right-turning
Mixer rod left-turning
Mixer attachment
Connection shaft mixer attachment
11.2 Service information
With this product, it is necessary to note that the fol-
lowing parts are subject to natural or usage-related
wear, or that the following parts are required as con-
sumables.
Wearing parts*: Mixer attachment, mixer rod, carbon
brushes
* may not be included in the scope of delivery!
Spare parts and accessories can be obtained from our
Service Centre. To do this, scan the QR code on the
front page.
12. Electrical connection
The electrical motor installed is connected and
ready for operation. The connection complies with
the applicable VDE and DIN provisions. The cus-
tomer's mains connection as well as the exten-
sion cable used must also comply with these reg-
ulations.
• The product fulfils the requirements of EN 61000-3-
11 and may only be used at the following connection
points: This means that use of the product at any
freely selectable connection points is not allowed.
• Given unfavourable conditions in the power supply
the product can cause the voltage to fluctuate tem-
porarily.
• The product is intended solely for use at connection
points that
a) do not exceed a maximum permitted supply im-
pedance "Z" (Zmax. = 0.25 Ω), or
b) have a mains constant current carrying capacity
of at least 100 A per phase.
• As the user, you are required to ensure, in consulta-
tion with your electric power company if necessary,
that the connection point at which you wish to oper-
ate the product meets one of the two requirements,
a) or b), named above.
www.scheppach.com
Article no:
5907803001
5907800702
5907800701
3907801009
3907801008