Ego Power+ HTA2000 Bedienungsanleitung Seite 13

TROUBLESHOOTING
CAUSE
PROBLEM
◾
The battery pack is not attached to the
hedge trimmer.
◾
No electrical contact between the hedge
trimmer and battery.
◾
The battery pack is depleted.
◾
The lock-off button is not depressed
before pressing the trigger.
◾
The battery pack or power head is too hot.
Hedge Trimmer does
not work.
◾
The blade is jammed.
◾
The hedge trimmer is not well connected
with the power head.
◾
Dry or corroded blades.
◾
Blades or blade support is bent.
Excessive vibration or
◾
Bent or damaged teeth.
noise.
◾
Loose blade bolts.
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.eu for full terms and conditions of the EGO Warranty policy.
SOLUTION
◾
Attach the battery pack to the hedge
trimmer.
◾
Remove battery, check contacts and
reinstall the battery pack.
◾
Charge the battery pack.
◾
Press down the lock-off lever and hold
it, then depress the trigger to turn on
the tool.
◾
Allow the battery pack or power head
to cool until the temperature drops
below 67°C .
◾
Remove the battery pack from the
tool. Remove the obstruction carefully
and then reinsert the battery and
restart the tool.
◾
Disconnect the hedge trimmer from
the power head. Reconnect them
following the section"INSTALLING AN
ATTACHMENT TO THE POWER HEAD"
in PH1400E/PH1420E/PHX1600
operator's manual.
◾
Lubricate the blades.
◾
Replace with a new blade or support.
Contact EGO service center for blade
or support replacement.
◾
Replace with a new blade or support.
Contact EGO service center for blade
or support replacement.
◾
Tighten the blade bolts. Using a
wrench, (not included), turn the bolt
clockwise to tighten.
HEDGE TRIMMER ATTACHMENT — HTA2000
EN
13