Beeper isivu Montageanleitung Seite 16

3. BEFORE INSTALLATION (end)
• The site of the monitor should not deteriorate the use of the orders of the car, airbages and other systems.
• The system functions under tension 12Vcontinuous.Be sure tension of the vehicle and polarity of eachwire (usea digital
multimeter to locate it or a lamp test).
• Check before the installaion if all the elements of thevehicle function correctly such as contact & driving starting,
lighting of the codes,fires and headlights, indicators, heating, air conditioning, locking of the doors,etc Check afterwards
installation that all these same elements
• Connect the sons only bg splice/welding without using thimbles. The badcontacts can create bad dysfunctions of the
sustem and the vehicle also. Takecare that all the sons passing in tight places are protected bu adhesivetape to avoid any
excessive torsion and degradation Ofthe plastic protection Ofthe wire with risk Of bad contacts. If the vehicle is equipped with
a airbag take care not to disconnect the battery from the vehicle, nor with to connect without certainty the sons.
Multiplexed vehicles
The system is compatible with the multiplexed vehicles. All the necessary information with connection are on sons with normal polarity
(about) on which does not forward a data (multiplexed BUSCAN, VAN or another coding). You should not imperativelu cut or touch a
multiplexed wire. IN ALL CA, IT USELESS AND IS DISADVISED CUTTING A WIRE OF ORIGIN OF THE VEHICLE. YOU MUST ONLY
MAKE ONE SPLICE AND RECOVER THE POSITIVE SIGNAL OR NEGATIVE FORWARDING BY THIS WIRE. For ang information or
council, we ask gou to contact our engineering services (contact@beeper.fr)
Vehicles prohibiting to connect a consumer on the beam reversing light
On certain vehicles +12 V reversing light is parasitized when the engine is moving what can disturb the good performance Ofthe radar Of
retreat or the kit camera of retreat. In other cases, this +12 V Reversing light does not authorize anu additional consumer. For all these
vehicles, To beep developed module RCAN R2 in order to recover information +12 V reversing light starting from network CANBUS This
module is connected on the CANBUS Ofthe compatible vehicle and makes it possible to deliver a +12V reversing light for the connection
of a radar or a camera of retreat (ref.: RCANR2, more information: http://beeper.fr/boutique/51-rcanr2.html)
function.