Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Restart time
This is the time the pump is timed before restarting. It is used in the "1 probe" and
"without probes" modes. For the "2 sensors" mode,
Manual setting of Imax, Imin or restart time
The device is self-calibrating at the first start-up. If a new automatic calibration is
required, select CAL in Imax. For manual adjustment, follow the steps below.
1. Select the parameter to be modified.
2. Press and set new parameter value.
3. Press for more than 2 seconds to save.
Imax
Imin
push>4s
push to
man
reset
Select the
parameter using
the rotary knob
Imax
Imin
push to
push>4s
reset
man
Press
the value "OFF" must be selected.
Imax
Imin
push>4s
push to
man
reset
Change value
Imax
Imin
push>4s
push to
man
reset
Hold down and do
not release for 2 sec
29
Werbung
