Specifications - Stihl Rca 20.0 Gebrauchsanleitung

English
Error LEDs on the
pressure was‐
her
or spray lance
are stiff.
19.2 Troubleshooting the Charger
Fault LED on Char‐
ger
Battery not being One LED glows
charged. red.
The LED fla‐
shes red.
The charger The LED
does not run a glows green for
self test. about 1 second
and then red
for about
1 second.
19.3 Greasing the gaskets
1
1
1
► Grease the gaskets (1) with grease suitable
for fixtures.

20 Specifications

20.1 STIHL RCA 20.0 Pressure
Washer
– Approved battery: STIHL AS
– Protection class: III
50
Cause
Cause
The battery is too
warm or too cold.
No electrical contact
between charger and
battery.
There is a malfunction
in the charger.
There is a fault in the
battery.
Electrical contact to
charger was briefly
interrupted.
1
1
Remedy
Remedy
► Leave battery inserted in charger.
Charging starts automatically as soon as
the permitted temperature range is rea‐
ched.
► Remove the battery.
► Clean contacts on charger.
► Insert battery.
► Do not use the charger and contact your
STIHL dealer for assistance.
► Do not use the battery. Consult a STIHL
dealer.
► Disconnect the mains plug from the
power supply.
► Wait for 1 minute.
► Insert the mains plug in a wall outlet.
– Max. pressure (p max.): 2.4 MPa (24 bar)
– Max. water supply pressure (p in max.): 1 MPa
(10 bar)
– Max. water throughput (Q max.): 3.9 l/min
(230 l/h)
– Minimum water throughput (Q min.): 2.4 l/min
(140 l/h)
– Max. suction lift: 1.5 m
– Max. water temperature in pressure mode
(t in max): 40 °C
– Max. water temperature in suction mode:
20 °C
– sample inspection
– Length: 329 mm
– Width: 82 mm
– Height: 233 mm
– Weight (m) without battery and with accesso‐
ries attached: 1.3 kg
Parameters dependent on pressure have been
measured at an inlet pressure of 0.3 MPa (3
bar).
For runtime, see www.stihl.com/battery-life.
20.2 STIHL AS Battery
– Battery Technology: Lithium-ion
– Voltage: 10.8 V
– Capacity in Ah: see rating label
– Energy content in Wh: see rating label
20 Specifications
0458-048-9601-A