MPM MOD-38 Bedienungsanleitung Seite 28

EN
6. Install the electric brush (14) in the lower slot of the main handle. Pay attention to the delicate pow-
er supply pins so as not to damage them. The main handle is equipped with a guide for mounting
the electro-brush in one correct position (fig.4).
fig. 2
7. Charge the vacuum cleaner battery as described in the section "CHARGING THE BATTERY".
CAUTION! The vacuum cleaner, power brush and main handle are equipped with electrical con-
nector pins. Do not damage or short-circuit them.
BATTERY CHARGING
CAUTION! Charge the battery before using the vacuum cleaner for the first time. The time re-
quired to charge the battery is approximately 4.0 – 4.5 hours.
CAUTION! Only charge the battery with the supplied charger. While the battery is charging, the
vacuum cleaner cannot be started.
1. Connect the charger cable (17) to the charger socket (20) on the docking station (fig.6).
2. Place the correctly assembled vacuum cleaner with the main handle and the electric brush on the
docking station (fig.7). Connect the charger to the power supply network.
Fig. 6
The status light (7) will flash to indicate that the battery is being charged.
3. A steady light (7) indicates that the battery has been recharged – disconnect the charger from the
mains when you plan to stop using the vacuum cleaner for a while.
4. Charge the battery after each use of the vacuum cleaner
CAUTION! Gentle heating of the charger is normal during the charging process.
28
Fig. 3
vacuum cleaner
guides
Fig. 4
Fig. 7
power
supply
pins
brush